Makita DUT130 Instruction Manual page 10

CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may
out
causing
or
CAUTION:
Do not install the battery cartridge
forcibly. If
not
it
inserted
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.3: 1. Indicator lamps 2. Check
button
Press the check
the battery cartridge
the remaining battery
indicator lamps light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature,
may differ
the actual
Tool / battery protection system
The tool is
a tool/battery protection system.
system automatically
power to the
extend tool and
The tool will
stop during operation if
tool or battery
under one of the following conditions:
accidentally fall
of the tool,
injury to you
someone around you.
the cartridge does
slide in easily,
is not being
correctly.
button on
to indicate
capacity. The
Remaining
capacity
Blinking
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The
may
malfunctioned.
the indication
slightly from
capacity.
equipped with
This
cuts off
motor to
battery life.
automatically
the
is placed
Overload protection
When the
is operated in
that causes
an abnormally high
tool automatically
any indication. In
turn the tool off and stop the application that caused the
tool to become overloaded. Then turn the tool on to
restart.
Overheat protection
When the
is overheated,
stops automatically.
case, let
battery cool
Overdischarge protection
When the
not enough,
automatically.
remove the
tool and
Switch action
CAUTION:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
CAUTION:
Switch can be locked in "ON"
position for ease of operator comfort during
extended use. Apply caution when locking tool in
"ON" position and maintain firm grasp on tool.
CAUTION:
Do not install the battery cartridge
with the lock button engaged.
CAUTION:
When not operating
ba
tool, depress the trigger-lock
from side to lock the switch trigger in the OFF
position.
►
Fig.4:
►
Fig.5:
Triggerlock button
To prevent
from accidentally
trigger-lock button is provided. To start the tool, depress
the trigger-lock button from A ( ) side and pull the
switch trigger.
increased by
switch trigger. Release the switch trigger to stop. After
use, depress the trigger-lock button from B ( ) side.
For continuous operation, depress the lock button while
pulling the switch trigger, and then release the switch
trigger. To
pull the
then release it.
10 ENGLISH
tool or
a
it to
current,
stops
this
tool or
the
In
the tool
before turning the tool on again.
battery capacity
the tool
In this
battery from
charge the
1. Trigger-lock button
1. Switch trigger 2. Lock button 3.
the switch
pulled,
Tool speed
increasing pressure on the
stop the
switch trigger
battery
manner
draw
the
without
situation,
battery
tool
this
and
is
stops
case,
the
battery.
the
button
trigger
the
is
tool,
fully,