Makita DUT130 Instruction Manual page 11

Speed change
NOTICE:
Use the speed change knob only after
the tool comes to a complete stop. Changing the
tool speed before
stops may
tool.
NOTICE:
Always set the speed change knob
carefully into the correct position.
you operate
speed change knob positioned halfway
the position
the position
tool may
damaged.
NOTICE:
If the rotation speed significantly
decreases during operation in the high speed
mode, stop the tool and change the mode to the
low speed mode. Otherwise, the
may get
cause a
or fire.
Two speed ranges can be preselected with the speed
change knob.
To change the speed, turn the speed change knob so
that the pointer points to the position 1 for low speed or
the position 2 for high speed. ► Fig.6:
Speed change knob
Accidental restart preventive
function
If you install
cartridge while pulling
trigger or locking the switch trigger, the tool does not
start. To start the tool, release the switch trigger, and
then pull the switch trigger.
Electronic function
The tool is
the electronic functions
operation.
•
Soft start
The soft-start function minimizes start-up shock,
and makes the
smoothly.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
the tool
damage the
If
the tool with the
between
1 and
2, the
be
motor
overloaded and
malfunction
1. Pointer 2.
the battery
the switch
equipped with
for easy
tool start
11 ENGLISH
Installing the front cover and side
grip
CAUTION:
Tighten the side grip firmly.
Otherwise, the
fall
injury.
►
Fig.7: 1. Front cover 2. Side grip
Attach the front cover to the tool and screw the side grip
on the tool
The side grip can be installed on either side of the tool.
Installing the shaft
Optional accessory
For DUT130
1. Tighten the shaft into the shaft holder.
►
Fig.8: 1. Shaft 2. Shaft holder
2. Tighten the shaft with wrench while holding the
shaft holder with another wrench. ►
1. Shaft 2. Shaft holder
For DUT131
1. Insert the shaft into the chuck as far as it will
go. ►
Fig.10: 1. Shaft 2. Chuck
2. Tighten the
hand, and
the chuck
each of
and tighten
Be sure
the chuck
all three
►
Fig.11: 1.
2. Chuck
Hook
To remove the
the chuck key
at one of
and then loosen
by hand.
Installing the mixing blade
Optional accessory
Attach the mixing blade on the top of the shaft, and then
secure it with the hex bolt.
►
Fig.12: 1. Mixing blade 2. Shaft 3. Hex bolt
NOTICE:
Be sure to attach the mixing blade with
"UP" mark facing the tool.
►
Fig.13: 1. Mark
Optional accessory
front cover may
and cause an
securely.
Fig.9:
chuck by
then place
key in
three holes
it clockwise.
to tighten
key at
holes evenly.
Chuck key
shaft, turn
counterclockwise
the holes,
the chuck