Device Safety System - Philips Willis the Whale Manual

Compressor nebulizer system
Table of Contents

Advertisement

Available languages

Available languages

Electromagnetic information: Portable and RF communication devices such as cellular
phones, pagers, etc. can interrupt operation of electrical medical equipment. For this
reason, your compressor must be placed far enough away from these devices to prevent
interference (no closer than 30cm/12 inches). This device meets IEC60601-1-2 standard
for electromagnetic compatibility (EMC).
In case of failure and/or malfunction, read the "Troubleshooting" section. Do not open the
compressor housing as this is not a serviceable product.
The proper function of the device can be compromised if original replacement parts
10
(e.g., filters) are not used.
To reduce risk of electric shock, DO NOT DISASSEMBLE.
11
Indoor use only.
12
Do not use the device without the filter.
13
Make sure that the electrical rating shown on the rating label on the bottom of the unit
14
corresponds to your main voltage and frequency before plugging in the device.
When using any electrical appliance, certain important safety measures must always be
15
followed, including the following:
• Use only manufactured-supplied original accessories and components;
• Never submerge the unit in water as the device is not protected against water penetration;
• Never touch the unit when your hands are wet or moist;
• Do not leave the unit outdoors;
• Place on a stable and horizontal surface when operating;
• Make sure the air vent openings are not obstructed; never place the product on a soft
surface, such as a bed or couch, where the air openings may be blocked. Keep the air
openings free of lint, hair, and the like;
• Do not allow unsupervised children or infirm individuals to use the unit;
• Do not turn off the unit by simply pulling out the plug from the electrical outlet;
• Do not use in a ventilator circuit;
• Do not use if the device has cracks or is damaged;
• Never drop or insert any object into any openings;
• Do not position the product on an uneven surface or where it is difficult to disconnect
the plug.
Do not use any adapter, single or multiple, and/or extension cord.
16
Do not leave the unit plugged in when not in use. Unplug the device from the electrical
outlet when not in operation.
Follow the manufacturer's instructions for installing the device. The manufacturer cannot be
held responsible for any damage caused by incorrect installation.
6
The power supply cord cannot be replaced by the user. In case the power supply cord
becomes damaged, contact Philips Respironics customer service for replacement (there
is no service option).
This device is for continuous use. Failure to operate appropriately may lead to
device damage.
Before performing any cleaning operation or filter replacement, disconnect the device from
the main supply by unplugging it.
Small parts can be inhaled, swallowed or dangerous. Cable, due to its length, may result in
provoking strangulation or asphyxiation. Do not leave the device alone with a small child or
physically challenged individual or an individual with learning difficulties.
If you no longer use the device, dispose of according to the local regulations in force.
Remember to:
• Use only manufactured-supplied original accessories and components;
• Do not use accessories, detachable parts and materials not described in these
instructions for use;
• Do not interconnect this equipment to other equipment not described in these
instructions for use;
• Use the accessories recommended by your doctor.
Use of accessories other than manufactured-supplied original accessories could result
in increased electromagnetic emissions or decreased electromagnetic immunity of this
equipment and result in improper operation.
This device is for indoor use only, device might not offer adequate protection to radio-
frequency communication services. The user might need to take mitigation measures, such
as relocating or re-orienting the equipment.
This device is not a toy. Do not use it as a toy.

Device safety system

Thermal protector
The device contains a thermal protector which will turn the device OFF if it overheats.
ATTENTION: Should the unit overheat, and the thermal protector activates, switch the unit
to the off "O" position, then allow the device to cool down for at least 40 minutes before
switching the unit back on.
ENGLISH
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents