Verifying Proper Operation - Dacor Preference PGM365-1 Installation Instructions Manual

Verifying Proper Operation
[_ WARNING
, Make sure that p0wer t0 the electrical outlet is turned
off atthe circuit breaker or fuse box and that the gas
is turned off at the gas supply valve before proceed-
ingl
i The c0oktop must be properlY grounded at al! times
when electrical power is applied!
Prior to operating the cooktop, read the accompanying use
and care manual carefully.
Make sure all the cooktop burner controls are in the
OFF position.
2. Connect the power cord to the electrical outlet.
3. Turn on power to the electrical outlet at the circuit
breaker or fuse box.
,
,
6.
Depress and rotate one burner control knob at a time
slowly counterclockwise to the HIGH position. Verify
that the associated burner igniter sparks, then return
the knob to the OFF position. Repeat for all of the
remaining control knobs.
Turn on the gas supply valve.
Perform the following ignition test for all of the burners:
• Press and turn the control knob slowly counter-
clockwise to the HIGH position. Only the selected
burner will spark. It will take approximately four
seconds for the burner to ignite, at which time the
igniter will stop sparking. If ignition does not occur
within four seconds, turn off the knob, wait for at
least two minutes to allow any gas to dissipate,
then repeat the test.
Once the burner lights, the control knob can be
rotated counterclockwise from HIGH to LOW to
adjust the flame height progressively. On dual burn-
ers turn the control knob to the simmer setting and
make sure the low level flame can be adjusted.
When the unit is installed properly, the flame will
be steady. It will also have a sharp, blue inner
cone that will
vary in length
proportional
to the burner
size. The flame
will be reduced
by the Smart
Flame
TM
fea-
ture under the
grate fingers to
increase grate
life.
Normal Flame Appearance
NOTE: If the cooktop does not operate properly, follow
these troubleshooting steps:
• Verify that power and gas are supplied to the cooktop.
• Check to make sure that the power plug is connected
to the electrical outlet and that power is turned on at
the circuit breaker or fuse box.
• Check to make sure that the burners are properly
seated.
• If the burner continues to spark after ignition without
stopping, have a licensed electrician check the electri-
cal outlet for proper grounding or reversed polarity.
• Repeat the above burner ignition test.
If the appliance still does not work, do not attempt to
repair the appliance yourself. Contact the Dacor Customer
Service Team at (800) 793-0093.
/
Light & high /
position T1
Area of
operation
/
Knob position
indicator
.ow
Area of position
operation
/
/ ',,
Low High
position position
Dual Burner Control Knob
Knob position
indicator
Light & high
position
\\\\\\
Area of _
operation ....."\
................. Low
position
Single Burner Control Knob
8 _mC_