Philips HDRW720/05 Quick Install Manual page 5

1 Switch off your TV set.
2 Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder.
3 Insert one end of the supplied aerial cable into the TV
OUT socket at the back of the DVD recorder and the other end
into the aerial input socket at the back of the TV set.
4 Connect socket EXT1 TO TV-I/O or sockets S-VIDEO OUT
(Y/C) , VIDEO OUT (CVBS) , AUDIO OUT L/R with the
corresponding sockets of your TV set.
Always check if the local mains voltage matches the voltage range
printed on the type plate at the back or bottom of the DVD-recorder.
If not consult your dealer or the customer support from your country.
1 Switch on the TV set.
2 Insert one end of the supplied mains cable into the mains socket
4MAINS at the back of the DVD recorder and the other end
into the wall socket.
1 Press STANDBY-ON m on the front of the DVD-recorder
P
' ' and then '
2 If necessary, select the programme number for the input socket at
the TV set.
P
The initial installation menu appears on the screen.
3 Select your favourite setting using B or A .
Confirm with OK .
4 Proceed in the same way with the further menus: '
', ' ', '
P
Autoinstall starts after the confirmation of the message '
P
When Autoinstall is complete, '
briefly appear on the TV screen.
5 End with SYSTEM MENU .
6 Press GUIDE/TV .
7 Select line '
' and confirm with OK .
8 Choose the entry position using C , D . Enter the local post
code of your location using A , B , or the number buttons
0..9 .
Depending on the country you select, you can also enter
letters using B or A .
9 Confirm the local post code with OK .
0 To end, press GUIDE/TV .
' will appear on the display.
' , ' ' .
' using OK .
' will
A B