8.1.4 SERVICE ILLUSTRATION
See Service Record Chart (Section 8.1.6)
This illustration shows the general location of
service points for all models in this manual.
On a regular basis check all
nuts, bolts and screws and
ensure they are all properly
secured
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Bucket
Linkage
38
Grease Fitting, 1/4NF
GX Models
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Main Boom
Pivot
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Bottom view
of Main Frame
On a regular basis check the condition of all hydraulic lines, hoses and
fittings. Replace any that are damaged. Re-route those that are rubbing,
pinched or crimped. Tighten any fitting that is leaking. Ensure fittings
are clean and free of dirt.
Look for this decal on
your machine, it indicates
a grease point and the
number of hours between
greasing.
Every 100 hours or annually,
wash and clean the backhoe,
remove entangled material,
wood chips, small debris
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Top of Swing
Cylinder
(two cylinders
on GX models)
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF
Grease Fitting, 1/4NF