Backhoe Mounting - Wallenstein GE605 Operator's Manual

4.7.3 BACKHOE MOUNTING

The Backhoe should always be located on a level, dry area that is free of debris and other foreign
objects. When attaching the Backhoe to the machine, follow this procedure:
1. Make sure that all bystanders, especially small children are clear of the work area.
2. For ease of attachment, have the backhoe on its shipping skid.
3. Make sure there is enough room and clearance to safely back up to the Backhoe.
4. Stop close enough to the backhoe so the hydraulic lines can reach the couplers on the tractor.
5. Attach the hydraulic system:
• Use a clean rag or paper towel to clean any dirt from around the coupler on the hose end and on
the tractor.
• Be sure to connect to the circuit that has a detent to allow for the steady flow of oil.
• Connect the hoses to the tractor couplers.
• Return line has a black nipple cover,
• Pressure line has a red nipple cover.
• Note: the backhoe is equipped with a directional valve and will not allow reverse flow if lines
are connected incorrectly.
• Be sure the couplers are securely seated.
6. Carefully use the dipper arm/stabi-
lizer legs to tilt the bracket / back-
hoe on an angle, so that the bottom
attach points line up with the attach
points on the tractor / skidsteer.
7. Follow the model specific instruc-
tions that came with the back-
hoe mounting kit to complete the
hookup.
WARNING
Collision Hazard
During setup, when operating
the boom and stabilizers, ensure the
area is clear of bystanders and operator
is safely positioned: see work zone /
safe zone. Run the engine at low RPM
and proceed cautiously.
WARNING
High Pressure Fluid Hazard
To prevent serious injury or death from high
pressure fluid:
• receive pressure on the system before
repairing or adjusting.
• wear proper hand and eye protection when
searching for leaks
• keep all components in good repair
24
Be sure to connect to the hydraulic
circuit that has a detent to allow for
the steady flow of oil.
CAUTION
Operation Hazard
Wallenstein backhoes have been de-
signed to rigidly attach to the frame of the tractor
/ skidsteer. Operating the tractors hydraulic 3
point hitch or bucket/loader controls on a skid-
steer while the backhoe is attached should be
avoided and will cause damage to the tractor
subframe / skidsteer tieback.