Western UltraMount MIDWEIGHT Installation Instructions Manual page 9

A‑FRAME TO BLADE ASSEMBLY
1. Align the pivot bolt hole on the A-frame with the
pivot bolt hole on the quadrant ("B").
2. Install the pivot bolt from the top. Secure with a
1" locknut and tighten the locknut as much as
possible while allowing the A-frame and quadrant
to pivot.
3. Move the snowplow into normal operating position.
4. Remove the protective packaging from the
angle rams.
A‑Frame/Lift Frame Assembly
Lit. No. 49583, Rev. 02
INSTALLATION INSTRUCTIONS
A
B
Pivot Bolt
C
1" x 3-5/16"
Clevis Pin
A
1" Locknut
9
5. Align the holes in the angle rams with the angle
ram holes on the quadrant ("A" and "C"). Attach
using the two 1" x 3-5/16" clevis pins from the top.
Secure with 1/4" x 2" cotter pins.
MIDWEIGHT™ Blade
Pivot Bolt
1" x 3-5/16"
Clevis Pin
A
B
C
1" Locknut
B
C
1/4" x 2"
Cotter Pin
1" x 3-5/16"
Clevis Pin
1/4" x 2"
Cotter Pin
PRO‑PLOW Series 2 Blade
®
1" x 3-5/16"
Clevis Pin
June 1, 2016