Western UltraMount MIDWEIGHT Installation Instructions Manual page 7

STAND SHOE
WARNING
The stand plunger spring is shipped
compressed and tied. Do not cut the spring
tie until final stand shoe adjustment is
complete and the roll pin is installed.
Initial stand shoe height adjustment is based on the
Pivot Plate Configuration chart. A final adjustment
of the stand shoe will be made after attaching the
snowplow to the vehicle.
1. Slide the stand shoe into the stand tube and align
the 1/4" hole in the stand tube with the 1/4" hole
in the stand shoe determined from the height
configuration chart and illustration.
Pivot Plate Configuration Chart
Dimension "D" Configuration
13.0" – 14.5"
14.5" – 16.0"
16.0" – 17.5"
17.5" – 19.0"
Configuration 4
(PRO-PLOW Series 2 only)
®
2. Insert a 1/4" roll pin.
3. Do not cut the spring tie until after the final stand
shoe adjustment.
Lit. No. 49583, Rev. 02
INSTALLATION INSTRUCTIONS
Stacking Stop
1 No
2 No
3 Yes
4 Yes
Roll Pin
Configuration 3
Configuration 2
Configuration 1
7 June 1, 2016