Western UltraMount MIDWEIGHT Installation Instructions Manual page 10

7‑1/2' AND 8' POLY BLADE SNOW
DEFLECTOR
POLY PRO‑PLOW Series 2 Blades Only
®
Align the holes in the rubber deflector material with
the holes in the poly blade frame top angle. Starting at
one end, align the end hole in the retainer bar with the
end hole in the deflector and blade frame top angle.
Loosely install 5/16" x 1-1/4" cap screws and locknuts
in the retainer bar holes.
Position the remaining retainer bars and loosely install
the fasteners.
Tighten the fasteners starting from the center of the
blade and working out toward each end.
5/16" x 1-1/4" Cap
Screws & Locknuts
Retainer Bars
Rubber
Deflector
Lit. No. 49583, Rev. 02
INSTALLATION INSTRUCTIONS
Retainer Bar
BLADE GUIDE ASSEMBLY
Insert the pointed end of the clamp into the coil of
the blade guide rod. Attach a blade guide rod to each
outer rib using 5/16" x 1" cap screws and locknuts.
Blade
Guide
Rod
5/16" x 1"
Cap Screws
10
Blade Guide
Flag
S-Hook
5/16"
Locknuts
Clamp
June 1, 2016