Western UltraMount MIDWEIGHT Installation Instructions Manual page 11

HEADLAMPS
WARNING
Your vehicle must be equipped with snowplow
headlamps and directional lights.
Headlamps, hardware and instructions are found in
the headlamp box. Additional hardware (two 1-7/8" flat
washers) can be found in the parts bag.
1. Attach the headlamps to the headlamp channel
according to the instructions provided in the
headlamps box, substituting the 1-7/8" flat washer
from the parts bag for the 1/2" flat washer packed
in the headlamps box.
Headlamp Swivel
Cable Tie
Anchor
Cable
Boot
Headlamp
Harness
Lit. No. 49583, Rev. 02
INSTALLATION INSTRUCTIONS
Grommet
1-7/8" OD
Flat Washer
(from parts
bag)
1/2" Lock
Washer
1/2" Nut
Headlamp
Harness
11
2. Insert seven cable tie anchors into the 1/4" holes
on the rear of the headlamp channel, from inside
the channel, with the locking tabs horizontal.
3. Install a split rubber grommet on each headlamp
wire 3" from the headlamp and insert the grommet
and wire into the slot on the rear of the channel.
4. Route the wires underneath the channel, in back
of the vertical supports, and down along the inside
of the driver-side vertical support, securing the
wires to the anchors with cable ties.
Headlamp
Harness
June 1, 2016