General Notes On Use; Switch On/Off / Standby; Navigation And Controls; Volume Adjustment / Mute - Hama DIT1010BT Operating Instructions Manual

5.1 General notes on use

5.1.1 Switch On/Off / Standby

• Press [POWER/VOLUME/ENTER/NAVIGATE] (9) to
switch on the tuner.
• Press and hold [POWER/VOLUME/ENTER/NAVIGATE]
(9) for 3 seconds to switch the tuner off (standby).
• To completely switch off the device, disconnect it from
the power supply.

5.1.2 Navigation and controls

• After pressing a shortcut button, navigate through the
menu items using.
• Select the individual menu items by turning [POWER/
VOLUME/ENTER/NAVIGATE] (9).
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (9).

5.1.3 Volume adjustment / mute

• Turn the volume up (right) or down (left) by turning
[POWER/VOLUME/ENTER/NAVIGATE] (9) accordingly.
• Press [ ] on the remote control to mute the tuner.
• Press [ ] again on the remote control to reset the
volume to the value before it was muted.

5.2 Connecting and starting up

Warning
• Only operate the product from a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• Disconnect the product from the power supply using
the On/Off switch – if this is not available, unplug the
power cord from the socket.
• If using a multi-socket power strip, make sure that the
total power consumption of all connected devices does
not exceed the power strip's maximum throughput
rating.
• If you will not be using the product for a prolonged
period, disconnect it from mains power.
• Connect the power supply to the mains connection (1) on
the back of the tuner.
• Connect the network cable to a properly installed and
easily accessible network socket.
• Wait until the tuner has initialised fully.
• Press [POWER/VOLUME/ENTER/NAVIGATE] (9) to
switch on the tuner.
Note – switching on for the first time
• The Setup Wizard starts up automatically when the
device is turned on for the first time.
• The default used language is English.
• You can skip the Wizard and start it up again later in
German.
Once the product has been connected to mains power,
initialisation takes place. The tuner is started.
To assist you with the first-time setup of the tuner, a Setup
Wizard is provided.
5.3 General notes on use
Notes on use
• These operating instructions always relate to operation
using the controls on the device. Functions that are
only usable by app or remote control are explained
separately.
• For information on the buttons on the remote control
and their functions ( ≙ ) that correspond to the control
buttons on the device, please see the Controls and
displays.
• [OK] and the navigation button ► on the remote
control correspond to pressing [POWER/VOLUME/
ENTER/NAVIGATE] (9).
• The navigation button ◄ on the remote control
corresponds to [ ] (4) on the front of the tuner.
• The navigation buttons ▲ / ▼ correspond to turning
[POWER/VOLUME/ENTER/NAVIGATE] (9) to the left
and right on the front of the tuner.
• When a selection among menu items is to be made
(such as YES or NO), the one currently selected has a
light-coloured background fill.
• In menus offering a variety of different options (such
as Equalizer, Update, and so on), the currently selected
option is marked with #.
9