Station Sequence; Search Setting; Search / Automatic Search - Hama DIT1010BT Operating Instructions Manual

Proceed as follows to do the settings:
• Press [ ] (1) to access the Settings menu.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to
navigate to the "Volume adjustment" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (9) and select your desired setting.

11.6 Station sequence

By default the tuner sorts stations into alphabetical order.
You can also sort by signal strength or ensemble. To
change the sorting order, proceed as follows:
• Press [ ] (1) to access the Settings menu.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to
navigate to the "Station sequence" menu item.
• Choose between "Alphabetic", "Provider" and "Valid"
and confirm your selection by pressing [POWER/
VOLUME/ENTER/NAVIGATE] (9).
12. FM
From the main menu or after pressing [ ] (2) repeatedly,
activate FM (FM radio) operating mode on the tuner.
Alternatively, press [FM] on the remote control to switch
directly to this operating mode.
Stations that broadcast additional information regarding
the station and the programme, are highlighted on the
display with an RDS icon (Radio Data System).
This additional information is displayed by pressing
] (6).

12.1 Search setting

The search setting allows you to determine whether
stations with low signal strength are ignored during the
automatic search. Proceed as follows:
• Press [ ] (1) to access the Settings menu.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to
navigate to the "Search settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (9).
• To have the search run stop only at stations with high
signal strength, select Strong stations only. Otherwise,
the search run will stop at every station for which a
signal is received.
Note
By default, the "Strong stations only" method is selected.

12.2 Search / Automatic search

• Press [POWER/VOLUME/ENTER/NAVIGATE] (9) to
start a station search.
• The tuner stops the search and starts playback when it
finds a station.
• Pressing [POWER/VOLUME/ENTER/NAVIGATE] (9)
again continues the search process until the next station
is found.
17
[