Manual Configuration Of Network Connection - Wireless (Wlan); View Settings - Hama DIT1010BT Operating Instructions Manual

PIN setup
• Select your desired network. (Indicated by the prefix
"[WPS...]")
• In the WPS menu, choose the PIN option and confirm
your selection by pressing [POWER/VOLUME/ENTER/
NAVIGATE] (9).
• The tuner generates an 8-digit code, which must be
entered into the web or user interface of your router or
access point.
• Consult the corresponding handbook for details on
configuring the router or access point.
Skip WPS / Pre-Shared Key (PSK) configuration
• Choose the item "[Skip WPS]" to proceed to key entry.
• On networks that do not support WPS, you will go
directly to key entry.
• In the input screen, enter the whole key and then confirm
with the OK button.
• If the key was entered correctly, the tuner connects to
the access point and establishes the Internet/network
connection.
Note
• Often the Pre-Shared Key is printed on the back of the
router or access point.
• When entering the key, take notice of capitalisation.
Open network / unsecured network
Note
• We recommend against establishing unsecured
connections and advise you to always protect your
network against unauthorised access.
• If you plan to use an open network, you just have to
select the network from the list of available networks
and confirm. The tuner then connects immediately
with the access point.
16.2.3 Manual configuration of network connection
– wireless (WLAN)
• To manually configure a network connection, proceed as
follows:
• Press [ ] (1) to go to the system settings.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to
navigate to the "Internet settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (9).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to
navigate to the "Manual settings" menu item.
Manual configuration wireless (WLAN) – DHCP
enable
• Select the option "Wireless".
• Selection the option "DHCP enable".
• In the input screen, enter the whole SSID (network name)
and then confirm with the OK button.
• Now choose the security standard used by the network.
This can be found in the configuration options of your
router or access point.
• Depending on the encryption used, you may need
to enter the network key before the connection is
established.
Manual configuration wireless (WLAN) – DHCP
disable
This method corresponds to configuration with an active
DHCP server (manual configuration wireless (WLAN)
- DHCP enabled), however you must also enter the
network information such as the IP address, subnet mask,
gateway address and DNS (primary and secondary).
Find this information in the web interface of your router
or access point, or if this information is already correctly
entered, you can confirm the entry. The tuner now attempts
to establish the connection.

16.2.4 View settings

This is where you will find all of the key information about
all network connections that the tuner is currently using, or
which have been set up, e.g.: MAC address, WLAN region,
DHCP enable / disable, SSID, IP address, subnet mask,
gateway address, DNS (primary/secondary), etc.
22