Running The Basic Appliance Care Programme - Siemens WT48XRH9GB Installation And Operating Instructions Manual

Hide thumbs Also See for WT48XRH9GB:
Table of Contents

Advertisement

If you are draining the
Note:
condensation water from the appliance
using the drain hose, reverse these
steps after running the basic or
intensive appliance care programme.
Running the basic appliance
care programme
To remove any dirt deposits in the
appliance, you can run the basic
appliance care programme.
Notes
After a certain period, your appliance
will automatically recommend that
you run the basic appliance care
programme. '§" will then appear on
the display for 5 seconds before the
programme starts, and again once
the programme ends. This message
will appear repeatedly until you have
run the basic appliance care
programme through to the end.
The basic appliance care
programme runs for approximately
one hour.
Run the appliance care programme as
follows:
Prepare the appliance for appliance
1.
care. ~ Page 47
Set the programme to position 1.
2.
Press and hold ü Drying Aim . At
3.
the same time:
Set the programme to position 4.
4.
'˜‚ and the programme duration will
now alternate on the display.
Pour approx. 1 ^ litre of warm tap
5.
water into the condensation
container.
Hold the full condensation
Note:
container horizontally at all times so
that no liquid spills out.
Slide in the condensation container
6.
until it clicks into place.
Press Start/Reload .
7.
The appliance care programme will start
and an audible signal will sound.
"Ÿš will appear on the display once the
appliance care programme has ended
and an audible signal will sound.
Appliance care
en
49

Advertisement

Table of Contents
loading

Table of Contents