Siemens WT48XRH9GB Installation And Operating Instructions Manual page 24

Hide thumbs Also See for WT48XRH9GB:
Table of Contents

Advertisement

Overview of programmes
en
ü Drying Aim : The dryness level defines how damp or dry the laundry is after the programme ends.
Ò Cupboard Dry
Plus
» Cupboard Dry
Ø Iron Dry
Drying level w
M Ready In N
M Ready In N
M/N
Less Ironing 60'
Less Ironing
120'
Low Heat
Start/Reload
Appliance setting Function
You can find out how to adjust the appliance setting on~ Page 29
Child Lock 3 sec. Disable the control panel to prevent unwanted or accidental operation.
Signal
--------
24
If you have set a dryness level, this is retained even after the appliance has been
switched off for the relevant programme. Exception: The settings are not saved for
Cottons.
Multi-layered, thick laundry that does not dry readily.
Normal, single-layered laundry.
Normal, single-layered laundry that still needs to be damp after drying and is suitable
for ironing or hanging up.
If you think the laundry is still too damp when the drying programme has ended, you
can adjust the degree of dryness to achieve a particular dryness level. To increase the
dryness level, set the degree of dryness to between Ô and ÔÔÔ. This extends the
programme duration but the temperature remains the same.
Once you have adjusted the degree of dryness for a dryness level, this setting is
retained even after the appliance is switched off.
Before starting the programme, you can delay the time at which the programme
ends by up to 24 hours using M and N.
The set time in hours, e.g. 8 h, is shown in the display and counts down until the pro-
gramme starts. Once the programme has started, the programme duration is dis-
played.
Note:
Observe the information about the ambient temperatures ~ Page 58.
The drying time for û timed programmes can be extended in 10-minute incre-
ments using M and N.
You can use the M and N selection buttons to adjust the setting values.
The drum moves the laundry at regular intervals after drying to prevent creasing. You
can activate or deactivate the automatic Anti-Crease function for 60 minutes (using
Less Ironing 60' ) or for 120 minutes (using Less Ironing 120' ).
Reduced temperature for delicate fabrics, e.g. polyacrylic or elastane, may increase
the drying time.
Starting, cancelling and interrupting a programme.
Use Signal to activate or deactivate the audible signal that sounds to indicate that the
programme has ended. If the setting has been selected, the button's indicator light
lights up and the signal tone is activated.

Advertisement

Table of Contents
loading

Table of Contents