Table of Contents
Advertisement
Help with the appliance
en
Laundry is not dried properly or
is still too damp.
Drying time too long.
Unpleasant odour in the appli-
ance
Humidity in the room is increas-
ing.
Unusual noises when drying.
54
After the programme has ended, warm laundry feels damper than it
■
actually is. Spread out the laundry and let it cool down.
Adjust the drying time or increase the degree of dryness. This will
■
extend the drying time but the temperature will remain the same.
Select a timed programme to add extra drying time for laundry that is
■
still damp.
Select a timed programme for a small load.
■
Do not exceed the maximum load for a programme.~ Page 22
■
Clean the moisture sensor in the drum. The sensor may become cov-
■
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.~ Page 46
Drying has been interrupted as a result of a power cut, because the
■
condensation container is full or because the maximum drying time
has been exceeded.
See also the laundry tips.~ Page 25
Note:
The appliance may have fluff in it. This will increase the required dry-
■
ing time.
– Clean the base unit. ~ Page 43
– Run a complete drying cycle with a load weighing more than
3 kg. Make sure the laundry has not been pre-dried.
Note:
The appliance's automatic self-cleaning function uses the
condensed water from your laundry. If you regularly dry loads weigh-
ing less than 3 kg, there will not be enough condensed water from
your laundry to run the appliance's automatic self-cleaning function.
You should therefore dry loads weighing more than 3 kg on a regular
basis, making sure that the laundry has not been pre-dried.
The heat exchanger may have fluff in it.
■
– Run the basic appliance care programme. ~ Page 49
If the fluff filter is damp, this may increase the drying time and affect
■
the drying result. Dry the base unit's fluff filter thoroughly after rins-
ing it.~ Page 43
If the air inlet on the appliance is blocked or not fully open, this may
■
increase the drying time. Make sure the air inlet remains unob-
structed.
If the ambient temperature is lower than 15 °C or higher than 30 °C,
■
this may increase the drying time and affect the drying result.
If the air circulation in the room is inadequate, this may increase the
■
drying time. Make sure the room is adequately ventilated.
Run the intensive appliance care programme. ~ Page 50
Make sure the room is sufficiently ventilated.
When drying is in progress, the pump and compressor generate noise
when operating normally. This does not indicate that the appliance is
malfunctioning.
Advertisement
Table of Contents
