Chapter 2
Installing the Router
Install the power cord with power cord lock and the pre-installed o-ring to mate with the power jack on
Step 2
the router. Make sure that the two arms of the power cord lock slide into the corresponding slots on the
router and are fully seated with both arms locking into the slots as shown in
Figure 2-14
To remove the power cord lock, use your thumb and index fingers to squeeze ends of tabs while pulling
Step 3
away from the router as shown in
Figure 2-15
Installing Power Cord Lock onto the Router
1
Power Cord Lock
Figure
2-15.
End of Tabs
1
Cisco 800M Series Integrated Services Router Hardware Installation Guide
Figure
2-14.
1
2-13