Installing Antennas; Installing The Router - Cisco 800M Series Installing Manual

Power off the router and disconnect the power cable from the power source.
Step 1
Place the router on its bottom side and remove the 3G Module by loosening the screws which are
Step 2
attached to the module.
The screws in 3G module are inbuilt to the module. For removing the module, you can loosen the screws.
Note
The 3G module comes out, but the screws will remain attached to the module.
Remove the SIM cover plate by removing the two counter-sunk screws towards the right side of the 3G
Step 3
module as shown in
Figure 2-10
Insert the SIM card by pushing it into the slot SIM0 or SIM1. You can also insert SIM cards in both the
Step 4
slots.
Note SIM 0 and SIM 1 are Push-Push slots. If the SIM card is pushed once, it gets inserted into the SIM slot.
If the SIM card is pushed for the second time, it is ejected from the SIM slot. The 3G module can have
SIM cards in both the slots. However, at a given point of a time, only one SIM card can be active.
After inserting the SIM card, replace the cover plate and tighten the 2 counter-sunk screws which were
Step 5
removed in
Step 6 Replace the 3G module into the Router and tighten the screws.
Please note down the MEID number before installing the module into the router. It is required to activate
Note
the SIM on certain carriers.

Installing Antennas

Note Before you install the Cisco 800M Series ISR on a table, wall or rack, install the antennas on the front
panel. It is difficult to install the antennas after the router is installed.
To attach the antennas to your router, follow these steps:
Remove the two rubber caps from the 3G Module.
Step 1
Cisco 800M Series Integrated Services Router Hardware Installation Guide
2-10
Figure 2-10.
Removing the SIM cover plate
Step 3.
Chapter 2

Installing the Router