Table of Contents
Advertisement
L
S
II T
S
YTE
CENE
OUCH
CREEN
Storing a Scene
Up to 13 Scenes can be "stored" (set in memory) using the ON and A-L buttons. After a Scene has
been stored, it can be recalled by pressing the corresponding Scene button.
Before a Scene is stored, the length of the fade must be set (fade rate). The Fade Rate pop-up menu is
used to set the length of the fade. After the desired fade rate has been programmed, press the Learn
button. This action will cycle the Scene button LEDs, asking where the scene should "stored." Pressing
a Scene button will store the current levels and fade rate into that Scene. The cycling will then stop and
the stored Scene button will illuminate.
To store a scene:
Step 1. Select a Master or Remote device for control. (Refer to
Control" on page
Step 2. Using virtual faders, make level changes for each channel as required.
Step 3. At
"Instant" setting.
Step 4. Press
Step 5. Press Scene button where you wish to store settings. Scene button will remain
illuminated, indicating that it is currently selected.
Press to store scene
Press arrows to toggle between
6-Button (ON, OFF, A-D) and
8-Button (E-L) panel icons
U
'
G
SER
S
UIDE
11.)
pop-up menu, select fade rate as required or leave in the default
Fade Rate
. Scene button LEDs will cycle.
Learn
Press 'Learn" to initiate
store sequence
Fade Rate Pop-up Menu
C
M
ONTROLLING A
ASTER
"Select a Master For
Virtual faders used to
change lighting levels
1 3
Advertisement
Table of Contents
