Table of Contents
Advertisement
Lock: This parameter is used to set the duration from successful matching to
unlocking. Select Lock and press OK to display the Lock interface.
Press
save your settings. For this parameter its unit of quantity is 1 second
and value range is 3—1 S, that is, 3—1 S seconds.
Note: The u nit of quantity and the maxi mu m value of this parameter h e r e
a re standard config urations. If you need larger parameter values, please consult
our commercial representatives or pre sales technical su pport engineers.
Verify Mode: Press O/ to display the Verify Mode interface, and press
a value. There are three optional values 0, 1, and 2 that represent
di4erent matching modes respectively, and the default value is 1
Verify Mode 0: Only the administrator can open the lock while the unlocking
function is disabled for ordinary users.
Verify Mode 1 : This is a default matching mode. Users can open the lock by
successfully matching their fingerprints only once.
Verify Mode 2: This is a dual verification mode. The administrator can open the lock by
successfully matching his/her fingerprint only once, but an ordinary
user has to pass the verification in any two matching modes by
using the same ID.
Normal Open: Press OK to display the Normal Open interface and press
select Yes or No. If you select Yes, a prompt will be displayed after
unlocking, inquiring whether you desire to select Normal Open. \t
you press OK, the system will prompt you that the NO function is
enabled and then power off automatically and immediately. The
Normal Open interface is shown as follows:
33 Fingerprint Lock User Manual
▲
▼
/
to select a value. Press ESC to exit current interface and
▲
▼
/
to select
▲
▼
/
to
Advertisement
Table of Contents
