Door Preparation 1. Check door thickness, prepare the proper screws and spindles. Door Thickness D Spindle J Screw L Screw F Screw 35-48 mm 30 mm 70 mm 10 mm 20 mm 48-55 mm 45 mm 55-75 mm 90 mm 60 mm Note: Screws and spindles for door thick ness of 55-75 mm are not included in the standard pack age.
Page 5
3. Check the required backset (60 mm or 70 mm). 70 mm 60 mm Note2: The latch has two backset options: 60 mm Note1: Installation template has the backset or 70 mm, please adjust it by yourself. options of both 60 mm and 70 mm.
Page 6
Tips 1. How to change the handle direction? Front Panel Back Panel 2. How to use emergency power? 9V Battery...
Page 7
3. How to use mechanical key ? Step1: Insert the equipped tool into the hole. Insert the key into key hole and rotate 90°. Step2: Rotate the tool at 90°, then pull out the cover. Cautions 1. New lock is defined as always open mode. 2.
Installation 1. Drill holes on the door 2. Install the latch (E) door thickness 35~75 mm center line of the handle desired handle height Note 1: Align the template along the vertical center line of the latch (E) at the desired handle height, and tape it to door.
Page 9
3. Install outdoor unit (B) with gasket (C) and spindle (D) on the door Note: Ensure the small triangle is vertically upward.
Page 10
4. Install mounting plate (I) with gasket (C) on the door 5. Install indoor unit (K) Note: Push cable into the hole .
Page 11
6. Install the battery (M) 7. Mark and drill holes for strike 2 mm (5/64") 12 mm (15/32") 21 mm (53/64") 14 mm (35/64") 35 mm (1-3/8") 8. Test the lock by mechanical key (A) or registered fingerprint...