Table of Contents
Advertisement
the user ID has already existed in the system; otherwise the system will display a
prompt "No Enroll" and you need to repeat the operation. After the PIN card is
successfully created only the ID number is stored in the PIN card.
2. Verify the PIN Card
Note: Set the parameter "Card Only" to "Yes". If you set the parameter " C a r d
Only to "No', you cannot verify with the created PIN card.
(2)When prompted to enter the user ID nu mbes,
pess
/
ioseIecihedesieduseID,andpess
▲
▼
OK The system then prompts you io "Show she
ca rd" (If the selected user ID does not exist in the
system, he system will dispay a pompt "No Enrol"),
as shown in the fgure on the let:
(JJSwipe your FP card through the card reader.
The interface as shown in the figure on the
lehisdisp ed:
bthe syaern gives a prompt "WrTe succ", your PIN
card is successfully created. You can replace the
fingerprint verification with the PIN card verification.
If the interface as shown i n the fig u re on the
left is displayed:
If the system gives a prompt "Write failed your PIN
card is not written in the system.
7ips: To ceatea PIN card,you need t o e n s u r e
Fingerprint Lock User Manual 24
Advertisement
Table of Contents
