Safety Regulations - MSA PointGuard Concrete Anchorage Connector Strap User Instructions

1

Safety Regulations

1.1 Correct Use
The PointGuard Concrete Anchorage Connector Strap is primarily a component of a personal fall arrest
system, serving as an anchorage connector. It may also be used for work positioning, travel restriction,
rescue, retrieval, evacuation and confined space entry/exit operations, depending on the associated
system components used together with the PointGuard Concrete Anchorage Connector Strap.
Use of the PointGuard Concrete Anchorage Connector Strap must comply with these user instructions
and, further, is subject to approval under the user's safety rules and regulations and by the user's
safety director, supervisor, or a qualified safety engineer. Be certain the selection of an anchorage
connector is suited for the intended use and work environment. If there is any conflict between these
user instructions and other directives or procedures of the user's organization, do not use the
PointGuard Concrete Anchorage Connector Strap until such conflicts are resolved. Consult all local,
state, and federal Occupational Health and Safety Administration (OSHA) requirements for personal
safety equipment. Also consult building codes and all other applicable laws and regulations.
1.2 Compliance
The product may comply with:
• ANSI Z359.18, Type A and / or;
• OSHA requirements
See product label for specific compliance notifications.
Anchorage connectors labeled with ANSI Z359.18 have been tested in compliance with the require-
ments of ANSI/ASSE Z359.7.
NOTICE
ANSI compliance and testing covers only the hardware and does not extend to the anchorage and
substrate to which the anchorage connector is attached.
1.3 Usage Specifications
• The PointGuard Concrete Anchorage Connector Strap has a minimum breaking strength of
5,000 lbs.
• The PointGuard Concrete Anchorage Connector Strap is designed for the attachment of a single
personal fall arrest system and use by one person.
• The MSA PointGuard Concrete Anchorage Connector Strap polyester webbing is 1.75 in
(44.5 mm) nominal width with a minimum breaking strength, when new, of 6,800 lbf (30.2 kN).
• Optional D-ring (hardware) is stamped steel, zinc plated, with a minimum breaking strength of
5,000 lbf (22.2 kN), and 100% proof tested to 3,600 lbf (16 kN).
• Must be used in conjunction with a personal fall arrest system under the supervision of a qualified
person. Fall arresting forces must not exceed 1,800 lbf (8 kN).
• The PointGuard Concrete Anchorage Strap is available in lengths between 3 and 10 feet (1 and
3 meters).
PointGuard Concrete
Safety Regulations
US
3