If a disc is loaded upside down, or if no
disc is loaded,
the CD player will not
If a badly
on the display.
occurs, replace the damaged
while a CD is playing could scratch the
and wait for the disc to stop
Both 8cm and 12cm discs can be played in
NOTE: Place only one disc at a time in the CD
Only discs bearing the logo as shown can be
played In this unit.
disc in the CD
with the label facing up. Com-
pact discs can be played on only one side.
wiped from the disc's signal surface (opposite
the label side) with a soft cloth. Gently wipe in
motion from the inside to the out-
side of the disc.
Discs should be returned to their cases after
use to avoid serious
cause the player to skip.
Do not expose a disc to direct sunlight,
or high temperatures
periods of time to prevent warping the disc.
Do not apply paper or write anything on either
side of the disc. Sharp writing instruments,
the inks used in some felt-tip pens, may dam-
age the surfaces of the disc.
Do not use cleaners
such as those
used for phonograph
WHAT TO DO IF...
If the operation
of the unit or display
normal , even though the appropriate
have been pressed.
the main lead.
Remove all batteries
(see page 2).
Set the FUNCTION
switch to TAPE.
Press the reset switch (back of the unit) for
at least 30 seconds.
Operate the unit.