Tandberg Data RDX QuikStor Quick Start Manual

A SUBSIDIARY OF
RDX® QuikStor™
Internal USB and Internal SATA
For More Information
Visit the support section of the Tandberg Data web site
(www.tandbergdata.com) for more information, including product
warranty and registration, knowledge base articles, user
documentation and technical support.
WHAT'S IN THE BOX?
2
1
for USB 3.0
for SATA
3
4
5
6
Power Ratings
The following power ratings represent typical-use performance
DC Input Voltage and
Power Source
Rated Input Current
USB 3.0
5V/0.9A and 12V/0.003A
SATA 5V/1.5A
Available External RDX Drives:
8782-RDX: Tandberg RDX External USB3+ Drive, bare
8781-RDX: Tandberg RDX External USB3+ Drive, with software
(Includes AccuGuard Server for RDX deduplication backup software)
1.
USB or SATA Cable
2.
Power Adapter Cable
for USB 3.0
3.
Mounting Screws
4.
AccuGuard License Activation Card
Note: AccuGuard software is only included with
for SATA
selected RDX products
5. Quick Start Guide
6. RDX Emergency Media Eject Pin
For RDX Warranty Registration and
Technical Support Activation visit:
http://registration.tandbergdata.com/
FCC Compliance Notice
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/ TV technician for help.