Adjustment Procedure; Preparation - RAYLASE AXIALSCAN-50 Manual

Chapter ‎ 5
5.3
The subsystem can be adjusted to different field sizes as follows. The field sizes that can be
set are listed in the data sheet. If you want to set a different field size, you must consult
RAYLASE for assistance.
5.3.1
o Load the correction file corresponding to the desired operating field size.
Make sure that you use the following identification code:
The following identification code is used for AXIALSCAN-50 type subsystems:
Type
AS-50
│
│ Aperture [mm]
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
└─ └─ └─ └────────└── └
XX-XX-XX_XXXX-XXXXxxx_XXXX.gcd
o Create all electrical connections for the power supply and for control of the subsystem
( page 12, Subsystem).
o For details of connecting the deflection unit to a RAYLASE control card and operation with
RAYLASE software, refer to the corresponding manuals.
20 RAYLASE 3-Axis Subsystem AS-50 for Laser Beam Deflection
Adjust field sizes

Preparation

AXIALSCAN-5ß
Coating code
Y
C
│
│ Field size range (min.-max.)
│ │
│ │ Type
│ │ st standard
│ │ │
│ │ │ Operating field size
Wavelength [nm] .............. Laser
1064 ......................... Nd:YAG
10600 ........................ CO2
Installation
MN049 / v1.0.0