Sparkfun Electronics LilyPad ProtoSnap Plus Hook-Up Manual page 16

1/22/2018
Arduino will compile the code, then send it to the LilyPad USB Plus via the USB cable. While the code is uploading,
the built-in LED will blink to signal the code is transferring. When the code finally runs, the RGB LED at the center of
the board will slowly blink green. Success!
If this all works, congratulations! You're all set up and ready to prototype with the LilyPad ProtoSnap Plus. Check out
our activity guide for more information on writing your own code to prototype for the ProtoSnap Plus:
LilyPad ProtoSnap Plus Activity Guide
DECEMBER 7, 2017
Learn how to program in Arduino with the LilyPad ProtoSnap Plus. This guide
includes 10 example activities that use the pre-wired LilyPad boards on the
LilyPad ProtoSnap Plus.
should not delete any sketches that you've created.
1. Open Arduino's "Preferences" window.
2. At the bottom of the window will be a link to your preferences file. Click on it and it will open a finder window.
https://learn.sparkfun.com/tutorials/lilypad-protosnap-plus-hookup-guide?_ga=2.234157401.659504291.1516640116-204410570.1509632255
LilyPad ProtoSnap Plus Hookup Guide - learn.sparkfun.com
Troubleshooting: Error
Messages on Upload?
If you are using a Mac and get an
error message like the following:
Board LilyPad U
COPY CODE
SB Plus (platfo
rm avr, package SparkFun) i
s unknown
It is possible that old Arduino
versions left over after updates are
interfering with the LilyPad USB
Plus support installation. If you
want to clear out this old
information, follow these steps:
WARNING: The following
instructions will delete any
extensions you've previously
applied to Arduino, returning it
to its factory-default state. It
16/23