Installation Instructions; Flow Diagram - Hans Grohe AXOR Starck 27830 Series Instructions For Use/Assembly Instructions

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
Children as well as adults with physical, mental and/
or sensoric impairments must not use this shower
system without proper supervision. Persons under
the influence of alcohol or drugs are prohibited from
using this shower system.
The shower system may only be used for bathing,
hygienic and body cleansing purposes.
Do not allow the streams of the shower touch
sensitive body parts (such as your eyes). An
adequate distance must be kept between the shower
and you.
The product may not be used as a holding handle. A
separate handle must be installed.
Shower hoses are only suitable for a connection
from the shower to the fitting. Never fit a shut-off
device between the fitting and the hose.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The fitting must be installed, flushed and tested after
the valid norms!
• The mesh washer must be insert to protect the
overhead shower against incoming dirt by pipework.
Incoming dirt leads to defects or/and can damage
parts of the shower; such caused faults voids all
liability and guarantee claims.
• Optimal functioning is only guaranteed with the
combination of Hansgrohe hand showers and
Hansgrohe shower hoses.
• Where the contractor mounts the product, he should
ensure that the entire area of the wall to which the
mounting plate is to be fitted, is flat (no projecting
joints or tiles sticking out), that the structure of the wall
is suitable for the installation of the product and has
no weak points. The enclosed screws and dowels
are only suitable for concrete. For another wall
constructions the manufacturer's indications of the
dowel manufacturer have to be taken into account.
4
English
Technical Data
Operating pressure:
Recommended operating pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:
Symbol description
Assembly see page 32
Do not use silicone containing acetic acid!
With the excentric washer it is possible to
equalize tolerance of the drilling. (see page
33)
Dimensions (see page 31)

Flow diagram

(see page 31)

Normal spray

Mono spray
Test certificate (see page 35)
Operation (see page 34)
Cleaning (see page 36) and
enclosed brochure
Spare parts (see page 35)
XXX = Colors
000 = chrome plated
820 = brushed nickel
max. 0,6 MPa
0,1 - 0,4 MPa
max. 60°C
max. 70°C / 4 min