Page 1
Dishwasher – Installation instructions Before installation, please read the safety precautions on the reverse side! Appliance components Recess for pipes >40 × 80 mm Front panel/decorative system Base Water tap Power socket Drain pipe Drain trap connection Aqua-Stop/inlet pipe Mains connection 1019614-R01...
Page 2
Dishwasher – Installation instructions EN Safety precautions Only move unpacked appliances using gloves. Do not lift appliance when on the plinth. Do not tip appliance over. Do not press on the sides or top of the appliance. Any old water supply and drain pipes must always be replaced with new ones. Always observe the local water supply authority’s regulations.
Dishwasher – Installation instructions Water/electrical connection <60 °C Water inlet 1,6 m Water outlet pipe ø 22 mm 1–10 bar Working pressure 0,1–1 MPa +5 °C Minimum ambient temperature 1,5 m Inlet pipe, Aqua-Stop G¾" Disconnect feeder If available: Remove Dummy and the non-return valve Clean drain trap.
Page 4
Dishwasher – Installation instructions Connect drain hose with drain trap Fix drain hose at the top with assembly set Fix drain hose with clamp max. 10 Nm Connect Aqua-Stop onto the tap Internal diameter of connection lead min. 18 mm For water pressure at <1 bar: Set to «low water pressure»...
Connection values: brown black blue yellow/green 4 × 1 mm² 3 × 1 mm² 3 × 1,5 mm² Tighten hoses and cables If available: Connect V-ZUG-Home Do not bend drain hose and the inlet hose Installation test Connect feeder again 1019614-R01...
Dishwasher – Installation instructions Empty the appliance Installation test Select the test by pressing and holding down the buttons at the same time Close appliance door The test starts in 15 seconds within 15 seconds It takes approx. 2 minutes If error messages occur: rectify fault according to the operating instructions U1/U2...