Advertisement
Dishwasher
Installation test
within 15 seconds
1. Initial set-up
EN
– Installation instructions
1.
Empty the appliance
2.
or
Select the test by pressing and holding down the
or
3.
Close appliance door
It takes approx. 2 minutes
4.
If error messages occur:
rectify fault according to the operating instructions
A2
Water outlet fault
5.
The installation test is complete when end of programme is displayed.
1.
Set the water hardness according to the «Using for the first time» section (see
operating instructions)
2.
Carry out the remaining work steps for the initial set-up
OK!
Appliance is ready for operation
+
at the same time
The test starts in 15 seconds
A9
Water inlet fault
+
buttons
U1/U2
Voltage fault
1019614-R01
Advertisement
