ECS RS482M-M Manual page 48

42
USB 2.0 Controller (Enabled)
Enable this item if your system supports USB 2.0.
USB Controller (Enabled)
This item enables the USB controller. Leave this at the default "Enabled" if you want to
connect USB devices to your computer.
USB Legacy Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto allows the
system to detect the presence of USB devices at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled.
USB Mouse Support (Enabled)
Enable this item if you plan to use a mouse connected through the USB port in a legacy
operating system (such as DOS) that does not support Plug and Play.
To creat RAID setup, users MUST connect the hard-disks to SATA1 & SATA2,
or SATA3 & SATA4.
Connecting the hard-disks to SATA1 & SATA3, or SATA2 & SATA4, does NOT
creat the RAID setup!
Press <Esc> to return to the Integrated Peripherals page.
Onboard SuperIO Device (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Onboard FDC Controller [Enabled]
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x
UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x
ECP Mode Use DMA
F5:Previous Values
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1/2 (3F8/IRQ4)(2F8/IRQ3)
This option is used to assign the I/O address and interrupt request (IRQ) for onboard serial
port 1/2 (COM1/2).
UART Mode Select (Normal)
• UR2 Duplex Mode (Half):This field is available when UART Mode is set to
either ASKIR or IrDA. This item enables you to determine the infrared function
of the onboard infrared chip. The options are Full and Half (default). Full-
duplex means that you transmit and send information simultaneously. Half-
duplex is the tranmission of data in both directions, but only one direction at a
time.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
SuperIO Device
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Half
[378/IRQ7]
[SPP]
[3]
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
F7:Optimized Defaults