Ipv6 Configuration; Inactivity Timeout; Carriage Return Translation - BayTech ATS27 Manual

Subnet Mask
The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the RPC to
determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists of
four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the MMP
can be accessed through the network.
Select 2), to enter the Subnet Mask followed by <cr>. Failure to enter the address in the decimal
form causes the unit to display the following until it is
entered correctly. Default Subnet Mask is 0.0.0.0.
Gateway Address
The Gateway is the address of a router to connect to other parts of a network. The Gateway address
consists of four bytes, each byte ranging from 0 to 255. If your network uses gateways, this
parameter must be programmed before the MMP can be accessed through the network.
Select 3), to change the Gateway address. Failure to enter the address in the decimal form causes the
unit to display the following until it is entered correctly.
Default Gateway address is 0.0.0.0.

IPv6 Configuration

Select 2), from Network Port
Configuration Menu to set the IPv6
network address.
Select 1), to change the IP address. Failure to enter the address in the decimal form causes the unit to
display the following until it is entered correctly.
Select 2), to change the Network Prefix Size
Select 3), to change the Gateway address. Failure to enter the address in the decimal form causes the
unit to display the following until it is entered correctly.

Inactivity Timeout

Select 3), from Network Port Configuration Menu to set the amount of time the unit will wait before
disconnecting if there is no activity. The enabling input
can be from 1 to 120 minutes. Default is 0 (DISABLED)

Carriage Return Translation

Select 4), from Network Port Configuration Menu to determine what the telnet processor will do
with the line-feeds and nulls after a carriage return is sent. Enable tells the unit Telnet processor to
strip line feeds or nulls after the carriage returns.
Disable allows the characters to pass through.
Default is "DISABLED".
Enter Subnet Mask in dotted decimal form :
Enter Gateway address in dotted decimal form :
Ethernet Address................
IPv6 Address....................
IPv6 Default Gateway............
IPv6 Address......................1
Network Prefix Size...............2
GateWay...........................3
Enter IP address in dotted decimal form :
Enter the network prefix size in bits :
Enter Gateway address in dotted decimal form :
Connection Inactivity Timeout is 0 minutes
Enter timeout, in minutes (<=120, 0 to disable) :
Carriage Return Translation is.... Enabled
Enable ? (Y/N), CR for no change) :
00:C0:48:0C:A6:D2
::/0
::