Wiring - Siemens FDCL221 Technical Manual

Mounting / Installation
5
Installation

5.2.1 Wiring

24 | 32
w Always insert a line separator before a sub-stub line.
1. Connect the line separator to the FDnet/C-NET. The pigtails are provided with
pressed-on 2.8 x 0.8 mm flat connector sleeves in the factory. Cut off the flat
connector sleeves if you don't need them for the connection.
2. Connect a sub-stub line to the same terminal on the FDnet/C-NET. The
following diagram shows one possible mounting variant where the individual
components are wired.
Figure 10: Wiring the components of an mounting variant
A Sub-stub line A
B Sub-stub line B
C Sub-stub line C
1 FDnet/C-NET detector line:
To the line module or to the next
FDnet/C-NET device
See also
2 Planning [➙ 18]
2 U-rail TS35
3 At least 3 sets of terminal blocks
4 FDnet/C-NET detector line:
From the line module or from the
FDnet/C-NET device
007063_h_en_--