5.2.1
Wiring
Building Technologies
Fire Safety & Security Products
Always insert a line separator before a sub-stub line.
1. Use a terminal to connect the line separator to the FDnet/C-NET. The pigtails
are provided with pressed-on 2.8 x 0.8 mm flat connector sleeves in the
factory. Cut off the flat connector sleeves if you don't need them for the
connection.
2. Use the same terminal to connect a sub-stub line to the FDnet/C-NET. The
following diagram shows one possible installation variant where the individual
components are wired.
Wiring the components of an installation variant
A Sub-stub line A
B Sub-stub line B
C Sub-stub line C
1 FDnet/C-NET detector line:
To the line module or to the next
FDnet/C-NET device
See also
Planning [
2 Top hat rail TS35
3 At least 3 sets of terminal blocks
4
FDnet/C-NET detector line:
From the line module or from the
FDnet/C-NET device
17]
Mounting / Installation
23
007063_e_en_--
09.06.2009