Mounting / Installation; Assembly - Siemens FDCL221 Technical Manual

Mounting / Installation

5

Assembly

5 Mounting / Installation
5.1 Assembly
22 | 32
The line separator may be fitted in any position. Ensure that the line separator LED
is visible after mounting.
You can fit the FDCL221 line separator in various ways:
● Directly on a U-rail TS35
● With a cable tie on the mounting hole
● With a screw on the mounting hole
Mounting on a U-rail TS35
Figure 7: Installing the line separator on a U-rail
1 Pair of terminal blocks
Mount the line separator to the U-rail.
l
– Slide the line separator onto the U-rail or
– Press the line separator onto the U-rail. You must be able to hear the line
separator click into place.
If you are mounting several line separators onto the same U-rail, we would
recommend using a pair of terminal blocks (at least 3 sets) after each line
separator. This results in a clear and space-saving form of mounting.
The terminal blocks must be ordered by the party responsible for installation.
For disassembly, simply slide the line separator off the U-rail or bend open the
locking catch on the line separator and remove the device from the U-rail.
The terminal block may feature the following forms of connection:
● Flat 2.8 x 0.8 mm plug-type connection (preferred choice)
● Screw terminals or socket strip
● Soldered connections
1
007063_h_en_--