Table of Contents
Advertisement
Installation
Installing the wine conditioning unit
If the wine conditioning unit is
pushed too far into the niche, the
door will not close properly. This can
cause ice to build up, condensate to
accumulate and lead to faults in the
appliance. These can all lead to in-
creased energy consumption.
Push the wine conditioning unit into
the building-in niche, making sure a
gap of 42 mm is maintained all round
between the appliance carcase and
the front of the housing unit side
walls.
Push the wine conditioning unit into
the niche until all fixing brackets at
the top and bottom touch the front
edge of the side walls of the housing
unit.
– With 16 mm thick unit walls:
The spacers should touch the front
edge of the housing unit side walls at
the top and bottom.
– With 19 mm thick unit walls:
The front edges of the top and bot-
tom hinges should be flush with the
front edge of the housing unit side
wall.
Check the position of the fixing
brackets at the top and bottom front
edge of the housing unit side wall
again.
78
This will create a gap all round of
42 mm to the front edges of the hous-
ing unit side walls.
Close the appliance door and align
the wine conditioning unit flush with
the surrounding cabinetry, pulling the
wine conditioning unit forwards if ne-
cessary.
Align the height of the wine condi-
tioning unit as necessary on both
sides with adjacent cabinetry by al-
tering the adjustable feet using the
spanner supplied.
Hide quick links:
Advertisement
Table of Contents
