Haier ES50V-F1(EU) Instruction Manual page 9

Use
Introduction to control panel
kW kW
Keys
Smart Mode
Smart
Enter the single tank mode
1.5KW
Enter the dual tank mode
3KW
Bacteria protection system
BPS
ON/OFF
After installation, firstly open the tap water inlet valve and the water outlet of the
water heater due to no water in the inner container in the first use, and then open
the mixing valve to allow the maximum hot water flow. Close the water outlet
after continuous flow from the shower nozzle or other water outlets which
indicates that the tank is water-filled. After confirming that all connections are
free of any leak, power it on. If the water heater is powered on first time, the
display is on for 1s, then the water heater goes into the status before power
failure.
Start-up
If the water heater is powered on, the display is on for 1s, then the water
1
heater goes into the status before power failure
2
Press
Smart mode
1
Press "Smart" to select number of people, and the numerical code is
alternately switched between 1, 2 and 3.
Numerical code 1 is on: for one-person bath;
Numerical code 2 is on: for two-person bath;
Numerical code 3 is on: for three-person bath;
2
The water heater will automatically complete heating as per the selected
number of people.
50L allows one-person bath and two-person bath;
80L/100L allows one-person bath, two-person bathand three-person bath.
to start up.
Icons
Smart mode Pilot light
Single/double tank
Double tank
Single tank
Setting Temperature/
Actual temperature
BPS mode Pilot light
9