Rain Bird IQ-NCC Installation And User Manual page 20

b
For IQNCCEN Ethernet Cartridges, route the supplied
RJ-45 Ethernet cable through the knockout in the
ENG
lower left of the unit.
b
Do not plug a phone cable into the IQNCCEN Ether-
net cartridge. This will damage the internal Ethernet
modem.
20 IQ Network Communication Cartridge
638085-02_20JA20_IQ-NCC user manual.indd 20 638085-02_20JA20_IQ-NCC user manual.indd 20
NOTICE
c
If required, install the type of connection module in
Slot 0 that is necessary for the intended configuration.
B
NOTE: If the satellite is being configured as a server
or a client with a wired connection (IQNet PE Com-
munication Cable) to another satellite, an IQ-FSCM-
LXME (for the ESP-LXD, ESP-LXIVM or ESP-LXIVM Pro)
connection module must be installed before pro-
ceeding. Refer to the Connection Modules section
of the Appendix for details. If no wired connection is
required, retain the base module that was shipped
with the controller. (The ESP-LXD, ESP-LXIVM and ESP-
LXIVM Pro controllers do not ship with a base module).
d
If a CM Port cable (Y-cable or straight) is installed,
connect the keyed mating connector to the CM
Connection Module as shown.
B
NOTE: The Y-cable may be used for a radio modem
wireless connection only. If a connection module is
not used, secure the unused cable end inside the sat-
ellite controller.
e
To establish a wired connection with another satellite,
route one end of an IQNet PE Communication Cable
through the knock-out on the bottom of the controller,
and attach the conductors to the blue terminals on the
CM Connection Module as shown.
1/20/2020 11:20:31 AM 1/20/2020 11:20:31 AM