Advertisement
QUICK START GUIDE FOR DEMONSTRATION CIRCUIT DC1104A
1. Connect the input power source to VIN termin-
als J1 or VIN and GND using a power supply
capable of handling 2.5A of current within a
13.5 to 20V range. The input supply voltage
MUST be greater than the full voltage value of
the battery to allow a full charge to take place.
2. Connect the load to VOUT and GND terminals.
3. Configure the jumpers for your specific battery.
BATTERY
+
-
MULTI CELL LI-ION BATTERY CHARGER BOARD
4. Plug in the battery.
5. Turn on the input power supply.
6. Optionally use the provided DC1223A-B dem-
OPTIONAL DC1223A-B SMBUS
TO USB ADAPTER
PROVIDES DATA LOGGING AND
BATTERY CONTROL
+
AMP Smart Battery connector is provided as
well as generic soldering Test Points for hard-
wire connections.
onstration software to configure and communi-
cate with the DC1104A.
-
Industry-standard 5 Pin
POWER
+
-
SUPPLY
LOAD
+
-
2
Advertisement
