Polygroup SUMMER WAVES Series Owner's Manual page 10

11. . Insert the ends of the 2 U-Shaped Pipe to the top frame.
12. Make sure the drain fitting is plugged securely and the cap is in place.
13. Start filling the pool with water until 1-inch of water is on the bottom, stop filling and smooth wrinkles out of the bottom of the pool. Push outward
from inside the pool removing all wrinkles so that it fills evenly and flat. IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE
SIDE BEFORE THE POOL STARTS FILLING IN THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED, SEE
"SETUP INSTRUCTIONS" ON PAGE 8.
14. Install the Filter pump by following the instructions in the "Swimming Pool Filter System" owner's manual. Once the filter pump is installed,
continue filling water into the pool.
15. When the water half filled, the top frame will tend to bend down at the middle. IT IS ABSOLUTELY NORMAL. Continue to fill water to the optimal
level, the frame will restore to its normal shape.
10