Data Transmission Options; Transfer; Overview; Starting Manual Transfer - Siemens SIMATIC KTP400 Basic Operating Instructions Manual

6.3

Data transmission options

Overview

The following table shows the options for data transfer between the HMI device and
configuration PC.
Type
Backup/restore,
Operating system update
Project transfers
Updating the operating system
with "Reset to factory settings"
Applies for operations with PC/PPI cable 6ES7 901-3CB30-0XA0 or USB/PPI cable
1)
6ES7 901-3DB30-0XA0.
6.4

Transfer

6.4.1 Overview
Transfer the executable project from the configuration PC to the HMI device.
You can start the "Transfer" mode manually or automatically on the HMI device.
Transferred data is written directly to internal flash memory of the HMI device. Parameterize
a corresponding data channel before you start the transfer.
6.4.2

Starting manual transfer

Introduction
You can manually switch the HMI device to "Transfer" mode as follows:
● At runtime, using a configured operator control.
● In the Loader of the HMI device.
Requirements
● The "*.hmi" project is open in WinCC flexible.
● The HMI device is connected to a configuration PC.
● The data channel is parameterized on the HMI device.
● The HMI device is in "Transfer" mode.
KTP400 Basic, KTP600 Basic, KTP1000 Basic, TP1500 Basic
Operating Instructions, 08/2008, A5E01075587-01
Data channel Basic Panels DP
Serial
1)
MPI/PROFIBUS DP
PROFINET
Serial
1)
MPI/PROFIBUS DP
PROFINET
Commissioning a project
6.3 Data transmission options
Basic Panels PN
Yes -
Yes -
- Yes
Yes -
- -
- Yes
63