Installing Several Smartline Appliances; Minimum Plinth Height; Worktop Depth - Miele SmartLine CSDA 7000 FL Operating And Installation Instructions

Installation notes
Installing several SmartLine
appliances
The gaps between the individual
SmartLine appliances are sealed with a
silicone sealant that is heat-resistant to
at least 160 °C. With flush-fit
installation, the gap between the
SmartLine appliances and the worktop
must also be sealed with a silicone
sealant that is heat-resistant to at least
160 °C.
After installation, the SmartLine
appliances must be easily accessible
from below, so that the bottom half of
the casing can be removed for
maintenance. If the SmartLine
appliances are not accessible from
below, the sealant must be removed so
that they can be removed.

Minimum plinth height

The downdraft extractor fan is installed
in the plinth below the cabinet floor. The
minimum plinth height is 100 mm.

Worktop depth

The downdraft extractor can be
installed with the connector for the air
duct on either the right or the left-hand
side.
Minimum worktop depth for
– right connector 600 mm
– left connector 665 mm
Housing unit back panel
The extraction ducting is laid behind the
housing unit back panel. The back
panel must be removable for
maintenance purposes.
30
Moisture collection tray
The downdraft extractor must be
installed in such a way that the moisture
collection tray is freely accessible and
can be removed for cleaning.