Mobilekey - Simons Voss Technologies SmartRelay SREL Series Manual

SREL1+2 (Manual)

6.2 MobileKey

You can enter the type of card reader here which the SmartRelay is to
simulate for operation as a serial interface.
The following options are available:
Wiegand, 33 bit

Wiegand, 26 bit

Primion

Siemens

Kaba Benzing

Gantner Legic

Isgus

External LED/external beeper

For SREL.ADV only: This indicates which external component group is
connected. In flip-flop mode, SmartRelay emits a permanent signal
when switched on if there is an external LED; if there is a beeper, an
audible signal is only emitted when there is a change of status.
Invert outputs

You can use these settings to invert the relay output.
A (MK) SmartRelay can be quickly configured in the MobileKey web app.
As a general rule, distinction is only made between an opening interval and
a permanent opening (flip-flop). A LockNode can be configured as an
option to connect the SmartRelay via a SmartBridge.
6. Configurations in the software
29 / 38