Advertisement
the lamp or touch the glass bulb! The glass can shatter and may cause injury.
ORDER REPLACEMENT LAMP
MODEL
TYPE NO.
SERVICE PART NO.
HOW TO CHECK LAMP USED TIME
The LAMP REPLACE indicator will light yellow when the total lamp used time (Corresponding
value) reaches 3,000 hours. This is to indicate that lamp replacement is required.
The total lamp used time is calculated by using the following expression:
Total lamp used time (Corresponding value) = Teco + Tnormal x 1.5
where:
To check the lamp used time:
1. Press and hold the ON STAND-BY button on the projector for more than 20 seconds.
2. The projector used time and lamp used time will be displayed on the screen briefly as follows.
WARNING MESSAGE ON THE NON-STANDARD LAMP USED
If a non-standard lamp is used, the warning and confirmation messages
will appear on the screen during each startup. Some of the functions are
limited when a non-standard lamp is used in spite of the warning.
2 of 4
For continued safety, replace with a lamp of the same type. Do not drop
LW555
003-120507-01
6103469607
Teco : used time in the Eco1, Eco2 and Auto mode
Tnormal : used time in the Normal mode and Auto mode
LX505
LX605
003-120531-01
003-120507-01
6103475158
6103469607
LW555 & LX505-605 Lamp-Filter Replacement Instruction Sheet
020-000239-03 Rev. 1 (07-2010)
Advertisement
