Using Redirector In Windows 2000/Xp - SystemBase Portbase-3010 User Manual

Portbase User Guide

2) Using Redirector in Windows 2000/XP

1) If Redirector is not installed in your system, install Redirector. (Refer to
chapter for more information)
2) If Redirector is installed in Windows 2000/XP, virtual driver is loaded on the system automatically
when the PC boots.
3) With the configuration program, you can identify that virtual COM ports are created. Alternatively,
you can also check "Ports (COM and LPT)" in Device Manager. (To open the Device Manager,
select Start
4) Run the configuration program by selecting Start
Port Redirector
5) If you like to change the IP address and the socket number of Portbase assigned to the virtual COM
port, click "Edit".
6) Enter the IP address, socket number (4001 to 4032) and the port name (32 bytes maximum) that
you like to edit. Click "OK" to apply new settings.
Setting Control Panel
Configure Installed Ports
System Hardware
All Programs
2.Installing Redirector
Device Manager)
SystemBase Portbase
in this
COM
71