Graco T-MAX 506 Quick Operator's Manual

WARNING
SET-UP
Connect pump module to hopper cart.
START-UP
Spray
Fill product hopper
with pre-mixed texture
Add water if thinning is
product. required. Mix thoroughly.
HDA531
HDA535
HDA541
HDA545
HDA651
HDA661
HDA671
Turn applicator OFF.
Use different
Turn ON/OFF switch
tip nozzle size
to ON.
to adjust flow.
STAR-TUP
Spray
Fill product hopper with
mixed texture product.
Turn applicator valve OFF.
Insert air nozzle.
www.graco.com
T-MAX
Quick Operator's Guide
This procedure is for water-based paints and flushing agents. For solvent-based paints and flushing agents (i.e. mineral spirits), you must first
read the section on Fire and Explosion Hazards in the Operating Instructions. Please note this Quick Guide is at no means replacing the official
Graco manual. Graco can at no means be liable for any consequences of not following the safety regulations as stipulated in the official manual.
* Please check the Graco operations manual supplied with the unit for more details.
WITHOUT Air < .25 mm
Turn pressure control
knob until steady stream
flows from product tube.
applicator OFF, turn tip 180° to
Turn pressure control to
maximum. To spray, aim CLEAN position, aim towards free
applicator at wall from area, turn applicator ON. When
0.5 m distance wall and
clog clears, turn applicator OFF
open applicator.
WITH Air <= 1.5 mm
Place product tube into hopper, turn ON/OFF switch to ON.
Turn control knob to 'green' section and allow material to product 30 sec.
Hold applicator over Turn air compressor ON. Turn pump
product hopper and turn control knob to 'green' section to
applicator ON. achieve desired product flow rate.
506/657
™
Turn pump control off (0).
Plug electrical cord into grounded outlet.
Install filter and tip
Turn pump OFF.
extension.
PRESSURE RELEASE PROCESS
Pressure Relief
DO NOT USE WITH
QUICK-SET MATERIALS
To clean clogged tip, turn
Turn pressure
control off (0).
and tip to SPRAY postion.
Turn pump control knob to
shut pump off.
Regulate air valve for
proper atomization.
Remove pump plug.
Connect product tube to pump outlet.
Screw tip assembly
Connect applicator
onto applicator.
to product tube.
2
2
Pressure
Relief
DO NOT USE WITH
QUICK-SET MATERIALS
Loosen nut on bottom
of pump
Aim applicator into
2-3 turns to
hopper.
release pressure.
Turn applicator ON.
Screw air hose and valve to applicator.
Connect product tube to gun.
To stop spraying,
turn applicator OFF.