Graco T-MAX 506 Quick Operator's Manual

WARNING
SETUP
Connect pump module to hopper cart.
STARTUP
Spray
Fill material hopper
with pre-mixed texture
Add water if thinning is
material. required. Mix thoroughly.
HDA531
HDA535
HDA541
HDA545
HDA651
HDA661
HDA671
Turn applicator OFF,
Turn ON/OFF switch
Use different tip size
to ON
for different flow
STARTUP
Spray
Fill material hopper with
mixed texture material.
Turn applicator valve OFF.
Install air nozzle.
www.graco.com
T-MAX
Quick Operator's Guide
This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing
fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.
* check the Graco operations manual delivered with the unit for more details.
without Air < .25 mm
Turn pressure control
knop until a steady
stream flows from
material hose.
applicator OFF, turn Tip 180°
Turn pressure control
to maximum. To spray, to Clean position, aim in waste
aim applicator with a area, turn applicator ON, when
distance of 0,5 m to the
clog clears, turn applictor OFF
wall and open applictor.
with Air <= 1.5 mm
Place material hose in Hopper turn ON/OFF switch to ON Turn
control in the "green" segment, allow material to circulate 30 sec.
Hold applicator over Turn air compressor ON. Turn pump
material hopper and turn control in the "green" area, until
applicator ON. desired material rate is achieved.
506/657
™
Turn pump control off (0).
Connect power cord.
Install filter and tip
Turn pump OFF.
extension.
PRESSURE RELIEF PROCESS
Pressure Relief
DO NOT USE WITH
QUICK-SET MATERIALS
To clean a tip clog, turn
Turn pressure
control off (0).
and tip in spray postion.
Turn pump control to
shut pump off
Regulate the air valve to
get a good atomization.
Remove pump plug.
Connect material hose to pump outlet.
Srew tip assembley
Connect applicator
onto applicator
to material hose.
2
2
Pressure
Relief
DO NOT USE WITH
QUICK-SET MATERIALS
Lossen nut on bottom
of pump
Point applicator
two to three turns to
into hopper.
relieve pressure
Turn applicator ON.
Screw air hose and valve to applicator.
Connect material hose to gun kit
To stop spraying,
turn applicator OFF