Specifications - WIKA TFS35 Operating Instructions Manual

8. Specifications

8. Specifications
Specifications
Temperature ranges
Reset Switching Temperature
(RST)
Ambient temperature
- Rectangular connector per
EN 175301-803
- AMP Junior Power Timer
connector
- Circular connector M12 x 1
Static operating pressure
Max. switching voltage
Electrical connection
Ingress protection
1)
1) The stated ingress protection only applies when plugged in using mating connectors that have the appropriate ingress
protection.
For further specifications see WIKA data sheet TV 35.01 and the order documentation.
WIKA operating instructions model TFS35
Typically 15 ... 40 K below the switching temperature
To ensure a safe reset of the switch at low switching
temperatures, care must be taken that the temperature
difference between the measuring point and environment
is high enough; since otherwise the switch cannot cool
back down to the reset switching temperature and thus the
instrument will not be able to return to its normal state.
Note:
Due to short installation length there is a risk that
the temperature at the connector will rise up to an
inadmissibly high value. This absolutely must be taken
into account when designing the measuring point. The
temperature at the connector must not exceed the above
mentioned temperature range.
-40 ... +100 °C
-40 ... +130 °C
-40 ... +90 °C
Max. 50 bar
Resistive load (cos ϕ = 1):
AC 48 V, 50/60 Hz, 3 A
■
DC 24 V, 3 A
■
DC 12 V, 4 A
■
Rectangular connector per EN 175301-803, form A
■
AMP Junior Power Timer connector
■
Circular connector M12 x 1
■
The ingress protection depends on the electrical connection.
Rectangular connector per EN 175301-803: IP65
■
AMP Junior Power Timer connector:
■
Circular connector M12 x 1:
■
EN
IP66, IP67
IP66, IP67
15