Subscribe to Our Youtube Channel
Related Manuals for Edwards E1M40/80
Summary of Contents for Edwards E1M40/80
- Page 1 A344-18-840 Issue B Original Support Instructions Replacement of the Flexible Coupling Insert Description Item Number ATEX HT Coupling insert (E1M/E2M/40/80) A21071137 ATEX HT Coupling insert (E1M/E2M175/275) A21071138...
- Page 3 For return of equipment, complete the HS Forms at the end of this manual. Illustrations Figure Page E1M40/80 and E2M40/80 pump motor and drive coupling ............3 E1M175/275 and E2M175/275 pump motor and drive coupling ........... 4 © Edwards Limited 2008. All rights reserved. Page i...
- Page 4 A344-18-840 Issue B This page has been intentionally left blank. Page ii © Edwards Limited 2008. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
- Page 5 3. Undo the screws securing the other side panel to the oil box and then remove the side panel. If you are replacing a flexible coupling insert on an E1M40/80 or E2M40/80 then continue at Step 4. If you are...
- Page 6 10. Tighten the four fixing bolts to a torque of 12 Nm. 11. Refit both side panels to the oil box. The pump is now ready to run. Note: There are no setscrews on the E1M40/80 or E2M40/80 coupling. 12. Refer to Figure 2.
- Page 7 A344-18-840 Issue B Figure 1 - E1M40/80 and E2M40/80 pump motor and drive coupling 1. M8 x 40 screw 2. Side panel 3. Side panel 4. Retaining ring 5. Elastic insert 6. Motor mounting © Edwards Limited 2008. All rights reserved.
- Page 8 Take particular care with the following: Fluoroelastomers that may have decomposed as a result of being subjected to high temperature. Page 4 © Edwards Limited 2008. All rights reserved. Edwards and the Edwards logo are trademarks of Edwards Limited.
Need help?
Do you have a question about the E1M40/80 and is the answer not in the manual?
Questions and answers